Drawmer-electronics M500 Dynamics Processor Manual do Utilizador descarregar pdf (Página 49)

M500 OPERATORS MANUAL Ch 6 - 5

SIDE CHAIN INSERT JACK

The side chain insert jack, (called S/C jack), on the rear panel of the M500 has several positions

in the control circuit dependent on the Effect assignment.

EFFECT MODULE SIDE CHAIN JACK USE

None assigned S/C Jack has no use, although input signal is present at the 'send'

contact.

GATE (direct S/C Jack has input signal for GATE detection.

source) Breaking the jack will stop the GATE operating.

GATE (internal S/C Jack has input signal post filter for GATE detection.

filter) Breaking the jack stops the GATE operating.

GATE (external S/C Jack has key input signal post filter for GATE detection.

filter) Breaking the jack stops the GATE operating.

EXPAND S/C Jack has input signal for EXPANDER detection.

Breaking the jack will stop the EXPANDER operating.

COMPRESS S/C Jack has input signal for COMPRESS detection.

Breaking the jack will stop the COMPRESSOR operating.

LIMIT S/C Jack has input signal for LIMIT detection.

Breaking the jack will stop the LIMITER operating.

De-Ess S/C Jack has no use, although input signal is present at the 'send'

contact. Breaking the jack has no effect.

Pan S/C Jack is in signal path of the PAN audio trigger and the PAN output

display meters.

Fader S/C Jack is in signal path of the FADE timer trigger and FADE output

display meters. Either side chain will trigger the FADE timer.

For other combinations of Effects the S/C jack signal route description can be assumed to be

similar to the following examples:-

GATE & De-Ess S/C Jack is used for the GATE only. Of course if the side-chain-jack is

broken then no signal will be output. So it could be said that the S/C jack

does effect both the assigned modules.

EXPAND, All modules are routed through the side chain.

COMPRESS &

LIMIT

When LINK INs is set to On the De-Ess, Comp, EXPAND, LIMIT Fx signals passing

through the S/C jack are averaged. Hence, when a side chain insert is necessary

both S/C jack insert points must be used, otherwise only a maximum change of

6dB signal level will be noticed.

INTERNAL BATTERY

Inside the M500 is a Nickel-Cadmium battery. This is kept charged whenever power is applied to

the unit. It is expected to last a minimum of five years, but extreme power conditions can shorten

this period. Symptoms of the battery failing are varied but will manifest itself as incorrect meter

level displays, 'ERROR 4' messages and irregular threshold response, especially on the GATE

Effect. Battery failure can aslo corrupt the USER PATCH titles and RECORDED ENVELOPES

preventing them from loading.

The battery is NOT

a user-serviceable component and no attempt should be made to change this.

Furthermore, any tampering with the battery will destroy the internal calibrations and User Patch

memories. If the battery is suspected of failing please return the M500 to your DRAWMER dealer

for service.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55

Comentários a estes Manuais

Sem comentários

Drawmer-electronics M500 Dynamics Processor Manual do Utilizador Página 49

Comentários a estes Manuais

Manuais e produtos relacionados com Áudio Drawmer-electronics M500 Dynamics Processor